BLOGas.lt
Sukurk savo BLOGą Kitas atsitiktinis BLOGas

Milling equipment ultra - ultrafine mill

Reasonable regulation of feed port of ultra - ultrafine mill
Milling equipment widely used, can be used for mining, construction, building materials, chemicals, roads and other industries for coarse crushing, crushing and fine powder operations. ultrafine mill complete sets of equipment to the host, the analyzer, blower, finished cyclone separator, piping device, motor and other components. The host by the rack, into the volute volute, blade, roller, grinding ring, casing and motor components. Auxiliary equipment jaw crusher, bucket hoist, electromagnetic vibration feeder, electric control cabinet, the user can choose according to the scene of the situation.
SBM Mining Machinery Co., Ltd. produced grinding machine grinding roller, grinding ring selection of special materials forged from, so that the degree of use greatly improved. In the case of fineness of materials and products, the fragile parts of the pyrophyllite ultrafine mill are 2-3 times longer than those of the impact crusher and the turbo pulverizer, usually up to one year; In the processing of calcium carbonate, pyrophyllite, calcite, the service life of up to 2 - 5 years; due to the grinding chamber without rolling bearings and screws, so there is no bearing and its seal vulnerable to the doubt, or because the screws loose Damage to the machine; the processing of the wood processing equipment, the fineness of the material can be a one-time D97 ≤ 5μm; roller mill equipment in the use of environmental protection and dust muffler greatly reduce the use of dust and noise on the surrounding environment No pollution.
Under normal operating conditions, the ultrafine mill inlet should be inside the suction, and blowing out several reasons are as follows:
1, check the connection with the pipeline is not a leaky local, this place when the wind inside the suction, not out of the hair must be careful;
2, check the throttle is not closed, the damper will also form a closed inlet blowing hair;
3, dust bag must be beat once a day, insist on breathable, the normal operation of the bag should be drum up.
4, the outlet of the pressure valve can not lift up, be sure to press down, the weight must be reasonable.
5, the feed must be uniform, do not form a mill block.

Patiko (0)

Rodyk draugams

Rašyk komentarą